15
Completing your first Scan
Before proceeding with the steps below, please finish the hardware and
software installation first. Refer to Quick Start Guide.
Original Image Placement
1. Raise the scanner’s document cover.
2. Place the document (graphic, text or photo) with face down on the
scanner. Center the document along the
triangular
mark.
3. Lower the document cover.
Start Your Scan by pressing push button
Before you prepare to scan the document to image editor ,e-mail application
etc, you must configure the values of the “push buttons”. Please refer to the
chapter “Configuring the Push Buttons ” for more details on settings of each
button.
1. Press the Scan, Copy or Custom button.
2. A Scan Progress window showing the status of the scanning task appears.
3. When the scan is completed, the image you scanned appears in the
application or device that you specified when you configured the button.
To Next Page
Loading...
Need help?
General
