10
For iMac/iMac DV and New Power Mac G3/G4 users
Configuring the Scan button Values
1. Click on the VistaAccess
icon in the control strip
with one mouse click. A pop
-up menu as shown on the
right appears.
2. Click the Push button
Configuration option. The Push Button
3. configuration window appears.
4. To Configure the Scanner button values. Select the image editing
software you want to scan to when you press the Scan Push button,
and the type of image you are scanning, the desired resolution, the
scanning intensity level, the size of the original image by clicking on
the arrow to the right in each field.
5. You could also click the check box “ Intelligent Image Process Engine”
in the “Push button Configuration” dialogue box to let the scanner do
all the settings for you
automatically. When you click
the check box, all relevant
fields will turn gray and the scanner does the correct Brightness
setting.
6. Click the OK button to save the Scan Push Button configuration
settings. These settings will be used whenever you press the Scan
button on the front of the scanner.
7. Push the Scan button. The scanner will start the scanning
process and scan the image to the specified image editing software.
To Next Page
Loading...
Need help?
General
