UMLo H6 - Storage; Cleaning and Maintenance; Empty Dust Bin; Clean Filter Component

EN-05 EN-06
2. Tap or wash the mesh filter with water; clean the HEPA filter with the cleaning brush.
Note:
1. It needs to be completely dried before being installed again.
2. The HEPA filter cannot be washed with water, replace it in time when necessary.
3. Make sure the filter component be in place when assembling.
Clean Filter Component
Remove the dust bin and dump the dirt.
If necessary, the dust bin can be washed with clean water. However, it needs to be completely dried before
being installed again.
HEPA Filter
Mesh Filter
1.
2.
Empty Dust Bin
Note: In order to maintain the suction power of the handheld vacuum, please clean the dust bin and filter
regularly.
Make sure that the product is turned off when cleaning.
Cleaning and Maintenance
1. Remove the dust bin, rotate the mesh filter counterclockwise to remove it, and take the HEPA filter.
Storage
Note: When do not use it for a long time, please place it in a dry place, and do not place it in direct sunlight
or a humid environment.