Figure 3
Figure 1
Figure 2
Battery
cover
BATTERY SAFETY INFORMATION
• Non-rechargeable batteries are not to be recharged
• Rechargeable batteries are only to be charged under adult supervision
• Rechargeable batteries are to be removed from the toy before being charged
• Different types of batteries or new and used batteries are not to be mixed
• Batteries are to be inserted with the correct polarity
• Exhausted batteries are to be removed from the toy
• The supply terminals are not to be short-circuited
Installing batteries into the remote control
Tool required - Small Phillips head screwdriver
1. Use a Phillips head screwdriver to remove the
battery door (see Fig. 3).
2. Insert 2 “AAA“ batteries. Make sure the “+” and
“-” ends are inserted correctly, as indicated in
the battery compartment.
3. Replace cover.
Installing batteries into Moon In My Room
Tool required - Small Phillips head screwdriver
1. Use a Phillips head screwdriver to remove the
battery cover (see Fig. 1).
2. Insert 4 “AA” batteries. Make sure the “+” and “-”
ends are inserted correctly, as indicated in the
battery compartment.
3. Replace cover.
4. IMPORTANT! Switch Moon in My Room to the “ON”
position before handing on the wall. (see Fig. 2).
PLEASE NOTE: The unit will not activate without the
remote control.
6+
2056
®
MOON
IN MY ROOM
MOON
IN MY ROOM
With Light-up Lunar Phases
To Next Page
Need help?
General
