24
Electric power supply connectionExternal probe connection (*)
- Predisposed on the terminal board, terminals
SE
See par. 4.5 positioning on the board
(*) Optional
NOTE!
Further details in the section
‘‘Technical Information’’ on the boiler page of
the www.unicalag.it website
The boiler is equipped with a power cable,
boiler installation requires electric al con-
nection to the mains power supply. This
connection must be made up to standard,
as required the regulations in force.
Remember that a bipolar switch must be
nstalled on the boiler power line with over
3 mm between contacts, easy to access,
making maintenance quick and safe.
The power cable must be replaced by
technical personnel authorised by UNI-
CAL AG S.p.A., using original spare parts
only. Failure to comply with the above can
jeopardise the safety of the appliance.
To Next Page
Loading...
