Need help?Do you have a question about the UnicalAir MDUN 10H and is the answer not in the manual?
General| Brand | UnicalAir |
|---|---|
| Model | MDUN 10H |
| Category | Air Conditioner |
| Language | English |
Guides on where to install the indoor unit, considering wall strength, obstructions, heat sources, power, sunlight, and accessibility.
Guidelines for placing the outdoor unit, avoiding heat/steam, wind/dust, high traffic, and ensuring proper air discharge and sound levels.
Specifies the operating temperature ranges for cooling and heating modes.
Instructions and diagrams for installing the wall hook bracket for the indoor unit, including leveling, fixing screws, and wall hole preparation.
General advice on handling and connecting refrigerant pipes, avoiding damage and repeated bending.
Steps for shaping connection pipes, removing caps, creating flanges, and connecting pipes to the indoor unit.
Procedures for connecting pipes to the outdoor unit, focusing on proper tightening torque to prevent leakage.
Table specifying tightening torque for different pipe sizes and corresponding stress levels.
Torque values for protection caps, crucial for sealing.
Emphasizes checking for refrigerant leakage after piping connection using a leak detector.
Steps for connecting electrical wires to the indoor unit terminals, emphasizing correct wire size and safety codes.
Procedures for connecting electrical wires to the outdoor unit terminals, matching indoor unit numbering and securing cables.
Checks to perform on the indoor unit after installation to ensure all functions are working correctly.
Checks to perform on the outdoor unit to verify noise, vibration, air flow, and coolant leakage.
Steps for connecting electrical wires to the indoor unit terminals for 18000-24000 BTU/h models.
Procedures for connecting electrical wires to the outdoor unit terminals for 18000-24000 BTU/h models.
Checks for indoor unit functionality after installation.
Checks for outdoor unit operation, noise, and leakage.
To Next Page