10
▀
Every Receiving Table can be set with the following parameters by PPS in accordance with the users'
requirements to satisfy the users' needs.
I
Pager Status operate on customer's radio system
Pager operate on different
system Receiving Table
Setting
Every receiving group of frequency Settings
1. There are 2 types of receiving groups
settings for every frequency
(a) Monitoring Mode (b) Selective Call
2. Selective Call is set that the talk group ID
(TGID) which would receive a certain specific
frequency.
3. Selective Call can be set more than one
TGID under the conventional system/ Single
frequency, however, since every freqeuncy
can set multiple protocols, so the TGID,
which would be listened, should be matched
up with the set protocols of the frequency to
set up different protocols with the same TGID
coding.
4. When it is in the Multi-frequency Priority
Scan Receiving Mode under the
Conventional system, Selective Call can be
set by Priority frequency normally (i.e.
multiple TGID can be set). However, when it
is with other Secondary frequency, it is
usually set as Monitoring Mode due to the
short stay time and it is unable to catch the
TGID in the Header certainly.
5. Multi-frequency Normal Scan Receiving
Mode in the Conventional system
(Note: the operating methods are different. If there
is signal, the frequency will stay. It will switch to
another frequency when the signal of that frequency
ended (Ending Code or Delay N) If the call has not
ended but the user would try to stop it and switch to
another frequency, please press the Back key.
In these frequencies of Scan, if the protocols
of some of the frequency are set as DMR or
P25C, it can also be set as Selective Call
and numerous TGID can be set. Since the
voice packages will transmit TGID and it can
distinguish Selective Call when it is the
protocols of DMR and P25C. However, if
Analog is being used with that frequency,
only Monitoring Mode can be used.
6. The operation of this Trunking system is
different from the normal Radio Trunking
system.
Multi-frequency priority
scan mode
Single frequency
Receiving Mode
Multi-frequency priority
scan mode
Set up by each channel and
protocols.
(Each channel is allowed to
set Multi-protocol and each
protocol is allowed to set
several TGIDs.)
Set up by each channel and
protocols.
(Each channel is allowed to
set Multi-protocol and each
protocol is allowed to set
several TGIDs.)
Set up by each channel and
protocols.
(Each channel is allowed to
set Multi-protocol and each
protocol is allowed to set
several TGIDs.)