unication G5 User Manual

9
Not Support Not Support
Free Scan
Pager Setting as Scanner
P25 / Phase # 2
Auto Detection
P25 / Phase # 1
Pager Setting operate on Trunking system
1. The way of Ending Code is commonly
used in the Trunking System. After each
receiving device received the Ending
Code, it will swtich back to Control
Channel.
2. However, Delay N should be set up as
well, in order to avoid that the users cannot
receive any Ending Code, when they
moved the another area with weakened
signals. (Ending Code is used together
with Delay N)
3. The definition of Out of Range Alert should
be Delay N→ back to Control channel →
When there is none of the Control Channel
signals found, then activate Scan to (scan)
search for Control Channel from all the
sites. → No signal → send out Out of
Range Alert → Set up the interval time of
the alert based on the PPS.
1. The way of Ending Code is commonly
used in the Trunking System. After each
receiving device received the Ending
Code, it will swtich back to Control
Channel.
2. However, Delay N should be set up as
well, in order to avoid that the users cannot
receive any Ending Code, when they
moved the another area with weakened
signals. (Ending Code is used together
with Delay N)
3. The definition of Out of Range Alert should
be Delay N→ back to Control channel →
When there is none of the Control Channel
signals found, then activate Scan to (scan)
search for Control Channel from all the
sites. → No signal → send out Out of
Range Alert → Set up the interval time of
the alert based on the PPS.
Not Support

unication G5 Specifications

General

Water Resistance	IP67
Frequency Bands	VHF, UHF, 700/800 MHz
Battery Type	Li-Ion
Alert Types	Vibration, Tone
Protocols	P25 Phase 1 & 2
Modulation	C4FM
Operating Temperature	-30°C to +60°C