Unico IS12MPA iSeries User Manual

Bulletin 30-122.2014.04.006 10 Copyright © 2014 Unico, Inc.
(SAC xx.xxxx.xxx.xx)
The remote communicates to the indoor unit with one of four different channels. Both need to be set to the same channel to
talk. The default is channel 1. If you have two indoor units in the same room and want to control them separately with their
own controller, they must each use a different channel. Set the remote controller as shown in the table.
WARNING
Disconnect the power
1. Disconnect the power of indoor unit.
2. Remove the batteries from the remote control unit.
3. Set the micro switches (see table). The switches are located in the battery compartment.
4. Insert the batteries in the remote control unit.
5. Set the channel in the indoor unit to match the same channel (see table).
REMOTE CONTROLLER
WALL MOUNT UNIT
CHANNEL
1
FACTORY
DEFAULT
1=OFF 2=OFF 3= OFF
4=OFF 5=ON 6=ON
SW1:
3=OFF
4=OFF
CHANNEL
2
1=ON 2=OFF
SW1:
3=ON
4=OFF
CHANNEL
3
1=OFF 2=ON
SW1:
3=OFF
4=ON
CHANNEL
4
1=ON 2=ON
SW1:
3=ON
4=ON
OFF
SW3
SW1
OFF
SW3
SW1
OFF
SW3
SW1
OFF
SW3
SW1
REMOTE CONTROL UNIT/INDOOR UNIT CHANNEL

Unico IS12MPA iSeries Specifications

General

Brand	Unico
Model	IS12MPA iSeries
Category	Air Conditioner
Language	English