Intended use
MV-Series | Version 2.01 5
2.4 Personal protective equipment
The personal protective equipment serves to protect per-
sons against impairments of safety and health while
working. The staff member has to wear personal
protective equipment while performing different tasks on
and with the machine which are indicated in the
individual paragraphs of these instructions.
The personal protective equipment is explained in the
following paragraph:
2.5 Safety labels on the mobile fan
The following safety labels are attached to the mobile fan
(Fig. 1), which must be observed and followed:
Fig. 1: Safety labels: 1 Warning of dangers | 2 Warning of dangerous
electrical voltage | 3 Warning of rotating machine parts |
4 Grounding symbol | 5 Flow direction | 6 Safety instructions
The safety labels attached to the machine must not be
removed. Damaged or missing safety labels can lead to
incorrect actions, personal injury and damage to pro-
perty. They must be replaced immediately.
If the safety symbols are not recognisable and compre-
hensible at first glance, the fan must be taken out of ope-
ration until new safety symbols have been applied.
3 Intended use
The fan is used exclusively for extracting and distributing
air and for cooling and drying objects. It is not explosion-
proof and is not intended for outdoor operation.
Intended use also includes compliance with all the infor-
mation in these instructions.
3.1 Reasonably foreseeable Misapplication
Any use beyond the intended use or any other use is
considered misuse.
Possible misapplications may include:
- Service work by untrained or unauthorized person-
nel.
- Operating the fan without functioning, intended pro-
tective devices.
- Operation of the fan in industrial areas.
Misuse of the fan can lead to dangerous situations.
In case of constructive and technical modifications to the
fan, the company Stürmer Maschinen GmbH does not as-
sume any liability.
Claims of any kind for damages due to improper use are
excluded.
3.2 Residual risks
Even if all safety regulations are observed and the ma-
chine is used in accordance with the regulations, there
are still residual risks, which are listed below:
- Fire hazard.
- Electrical hazard due to contact with parts and high
voltage (direct contact) or with parts under a high
voltage due to a defect of the device (indirect con-
tact).
- Upper limb hazard due to accidental contact with the
impeller.
Head protection
The industrial helmet protects the head against
falling objects and bumping against fixed objects.
Protective gloves
The protective gloves are used to protect the hands
from sharp-edged components, as well as from
friction, abrasions or deeper injuries.
Safety boots
The safety shoes protect the feet against bruising,
falling parts and slipping on slippery surfaces.
Protective clothing
Protective clothing is tight-fitting work clothing, with
no protruding parts, with low tear resistance.
2
3
4
1
6
5
To Next Page
Loading...