2 WPP 10 TE | Version 2.05
Imprint
Product identification
Hydraulic workshop press Item number
WPP 10 TE 630 0011
Manufacturer
Stürmer Maschinen GmbH
Dr.-Robert-Pfleger-Str. 26
D-96103 Hallstadt
Germany
Fax: 0049 (0) 951 - 96555-55
email: info@unicraft.de
URL: www.unicraft.de
Information about the operating instructions
Genuine operating instructions
Edition: 27.08.2020
Version: 2.05
Language: English
Author: DM/MS
Copyright information
Copyright © 2020 Stürmer Maschinen GmbH, Hallstadt,
Germany.
Stürmer is the sole owner of the content of these operat-
ing instructions.
Forwarding and reproduction of this document as well as
use and notification of its content is not permitted without
explicit consent. Infringements shall oblige to payment of
compensation.
Subject to technical modifications and changes.
Contents
Imprint ........................................................................ 2
1 Introduction .............................................................3
1.1 Copyright ............................................................3
1.2 Customer service................................................3
1.3 Disclaimer...........................................................3
2 Safety........................................................................3
2.1 Legend of symbols..............................................3
2.2 Operator responsibility........................................4
2.3 Operating staff qualification ................................4
2.4 Personal protective equipment ...........................5
2.5 Safety identifications on the workshop press......5
3 Intended use ............................................................5
4 Technical data .........................................................6
4.1 Table...................................................................6
4.2 Environmental conditions....................................6
4.3 Type plate...........................................................6
4.4 Pressure gauge ..................................................6
5 Transport, packaging, storage...............................6
6 Machine description................................................7
6.1 Scope of supply ..................................................7
6.2 Accessories ........................................................7
7 Setup ........................................................................8
8 Installation ...............................................................8
9 Commissioning .......................................................9
9.1 Adjusting the table height .................................10
9.2 Setting up the work area..................................10
9.3 Adjusting the horizontal working position..........10
9.4 Aligning hydraulic cylinders ..............................10
9.5 Building up pump pressure...............................10
9.6 Retracting hydraulic cylinders...........................10
9.7 Processing the workpiece.................................11
10 Maintenance and repairs ....................................11
10.1 Cleaning maintenance....................................11
10.2 Maintenance and repairs ................................11
11 Disposal, reusing used machines .....................13
11.1 Decommissioning ...........................................13
11.2 Disposing of lubricants....................................13
12 Spare parts...........................................................13
12.1 Spare parts orders..........................................13
12.2 Spare parts drawings......................................14
13 Hydraulics circuit diagram ................................15
14 Maintenance plan ................................................16
15 EC Declaration of Conformity ............................17
To Next Page
