Need help?Do you have a question about the Unifore VS-WJP1 and is the answer not in the manual?
Install three AAA batteries into keypad base, observing polarity, then secure the cover.
Mount keypad by fixing base screws to wall/door, then attach the keypad unit securely.
Arm/Disarm keypad twice during panel's learning mode for successful pairing. Expect confirmation.
Enter learning mode with code, swipe RFID tag. Success indicated by beep. Supports up to 60 tags.
Enter delete mode with code. A single long beep confirms all RFID tags have been successfully deleted.
Arm the panel for 'away' mode by entering code and pressing 'Away Arm'. Success confirmed by beep.
Disarm the panel using keypad code or RFID tag. Entry of correct code/tag triggers disarm signal.
Press '*' then swipe RFID tag twice. Keypad confirms with beeps and sends disarm signal to the panel.
Follow guidelines for longevity and safety, including general use, forbidden installations, and decomposition rules.
Clean exterior with soft cloth. For dirt, use alkaline fluid and a soft cloth, then dry the keypad.
To Next Page
General