What to do if Unigas Burner doesn’t start?
If the Unigas Burner doesn’t start, check the following possible causes: * Mains switch should be open. * Fuses intervention. * Maximum pressure switch fault. * Ignition transformer fault. * Ignition electrode dirty or bad position. * Dirty nozzle. * Fuel solenoid valve defective. * Fuel low pressure. * Fuel filters dirty.
Why Unigas Burner starts and locks?
If the Unigas Burner starts and then locks, a possible cause is a flame control box fault.
What to do if Unigas Burner locks and repeats cycle during operation?
If the Unigas Burner locks and repeats the cycle during operation, check for the following: * Flame control box fault. * Smoky flame.
What to do if Unigas Burner doesn’t start and locks?
If the Unigas Burner doesn’t start and locks, check the following: * Flame control box fault. * Phoresistance dirty or defective.
What to do if Unigas Burner doesn't switch to high flame?
If the Unigas Burner doesn’t switch to high flame, it could be due to: * Flame control box fault. * High - low flame thermostat defective. * Bad position of actuator cams.
What to do if Unigas Burner lock during operation?
If the Unigas Burner locks during operation, a possible cause is servocontrol fault.
Why won't the Unigas IDEA Indoor Fireplace burner start?
The burner of your Unigas Indoor Fireplace might not start due to several reasons. It could be due to an open main switch, in which case you should continue with pre-purge. Other potential causes include a lack of gas, a defective maximum gas pressure switch (if provided), defective thermostats or pressure switches, a faulty control box, a defective servocontrol (if provided), a fault or bad setting in the air pressure switch, a defective minimum gas pressure switch, a dirty gas filter, an ignition transformer fault, bad positioning of the ignition electrodes or detection electrode, a bad setting of the butterfly valve, a defective gas governor, a defective gas valve, a bad connection or defective high/low flame thermostat or pressure switch (if provided), a wrong setting of the servo cont...
Details on burner model identification and technical specifications.
Provides detailed dimensions and technical data for LO280 and LO400 models.
Instructions for packing, fitting the burner to the boiler, and connections.
Diagrams and guidelines for electrical connections of the burner.
Visual representation of the fuel oil piping system.
Details on operating single-stage and double-stage burners.
Regular maintenance tasks including filter inspection and cleaning.
Table of common problems, causes, and solutions for the burner.
Electrical wiring diagrams for single and double stage burners.
General| Brand | Unigas |
|---|---|
| Model | IDEA Series |
| Category | Indoor Fireplace |
| Language | English |
To Next Page
