II UPS469-01-00 PowerWAVE 3000T User Manual Dated 05-04-13
4.3 Description of the LCD display 4-3
4.3.1 Status screens 4-3
4.3.2 Main menu screen 4-3
4.3.3 Event log menu screen 4-4
4.3.4 Measurements menu screen 4-4
4.3.5 Commands menu screen 4-5
4.3.6 UPS Data menu screen 4-5
4.3.7 Set-up User menu screen 4-5
4.3.8 Set-Up Service menu screen 4-6
4.4 Operating Modes 4-6
4.4.1 On-Line (Inverter) mode 4-6
4.4.2 Bypass (Off-line or ECO) mode 4-7
4.4.3 Maintenance Bypass Mode 4-7
4.5 Operating Instructions 4-9
4.5.1 Transfer to Maintenance Bypass Mode 4-9
4.5.2 Starting the UPS system from the Maintenance Bypass mode 4-11
4.5.3 Complete system shutdown 4-13
5 Maintenance
5.1 Introduction 5-1
5.2 System calibration 5-1
5.3 User responsibilities 5-1
5.4 Routine maintenance 5-1
5.5 Battery Testing 5-2
5.6 Battery Maintenance 5-2
5.7 Battery Disposal and Recycling 5-2
6 Troubleshooting
6.1 Alarms 6-1
6.2 Menu, Commands, Event Log, Measurements, 6-1
6.2.1 Event log screen 6-1
6.2.2 Fault identification and rectification messages and alarms 6-2
6.3 Contacting Service 6-2
7 Options
7.1 Introduction 7-1
7.2 Remote Emergency Stop facilities 7-1
7.3 Generator ON facilities 7-2
7.4 Remote Signalling Panel 7-3
7.4.1 Remote Singalling Panel connections 7-4
7.5 WAVEMON Shutdown and Management Software 7-5
7.5.1 Why is UPS Management important? 7-5
7.5.2 WAVEMON Shutdown and Monitoring Software 7-5
7.6 SNMP CARD/ADAPTOR For Network Management/Remote Monitoring 7-6
8 Specifications
8.1 General Data 8-1
8.2 Rectifier Data 8-2
8.3 Battery Data 8-2
8.4 Inverter Data 8-2
8.5 Communication Options 8-3
8.6 Mechanical 8-3
8.7 Fuses & Cables Quick Reference 8-4
To Next Page
Loading...
Need help?
General