Why doesn't the oil pressure gauge function during operation of my UnionSpecial Industrial Equipment?
If the oil pressure gauge isn't working during operation, the line filters may be clogged with foreign material. Replace the built-in line filters.
Why are my threads breaking while sewing with my UnionSpecial BC200 Sewing Machine?
Thread breakage during sewing can occur for several reasons. First, check that the threads are separated from any interference between the thread cone and the sewing machine. Another cause may be a blunt looper tip, in which case you should stone off the burr or replace the looper. Finally, a blunt needle tip can also cause thread breakage, so replace the needle.
What to do if feed cuts appear on the bottom of the bag when using my UnionSpecial Sewing Machine?
If you notice feed cuts on the bottom of the bag, it could be due to excessive chaining and presser foot pressure. Try reducing the pressure using the pressure screws. Alternatively, the feed dog teeth might be too sharp; in that case, slightly stone the tips of the feed dog teeth.
What to do if I see malformed stitches on my UnionSpecial Sewing Machine?
Malformed stitches can occur if the thread isn't correctly placed in the thread tension assembly or eyelets. Make sure to thread according to the threading diagram.
Why is tape torn in the stitch area on my UnionSpecial BC200?
Torn tape in the stitch area often results from excessive needle thread tension. Reduce the needle thread tension using the needle thread tension assembly.
Why is tape torn in the stitch area when using UnionSpecial Industrial Equipment?
Torn tape in the stitch area is often due to excessive needle thread tension. Reduce the needle thread tension at the needle thread tension assembly.
What to do if the feed cuts on the bottom of the bag with UnionSpecial Industrial Equipment?
If the feed is cutting the bottom of the bag, this may be due to excessive chaining and presser foot pressure. Try reducing the pressure at the pressure screws. Alternatively, the feed dog teeth may be too sharp; stone the tips off slightly.
How to fix skipped stitches at the start of the bag with UnionSpecial Industrial Equipment?
Skipped stitches at the start of the bag can occur if the chain section isn't clamping properly. Ensure the chaining section is set to the correct specification.
How to prevent the feed from cutting the bottom of the bag with my UnionSpecial BC200?
To prevent the feed from cutting the bottom of the bag, there are a couple of things you can try. First, reduce the pressure at the pressure screws if there is too much chaining and presser foot pressure. Also, if the feed dog teeth are too sharp, stone the tips off slightly.
What to do if the oil pressure gauge doesn't function during operation of my UnionSpecial Sewing Machine?
If the oil pressure gauge isn't working, the line filters may be clogged with foreign material. Replace the built-in line filters to resolve this.
Describes different machine types and their features.
Details needle types, sizes, and specifications.
Specifies torque values for various machine parts.
Highlights hazardous zones and precautions.
Details on initial oil filling and regular oil/filter changes.
General| Brand | UnionSpecial |
|---|---|
| Model | BC200 |
| Category | Sewing Machine |
| Language | English |
To Next Page
