ENGLISH ENGLISH
10 11
• Turn the Relief Valve to down position to release steam.
Note: When cooking fluid food, such as porridge, to avoid squirting up remember not to release
the steam immediately after 3 sound signals. Let the pressure cooker cool down naturally.
Otherwise the fluid food may squirt and result in damage.
• Remove the plug from the socket.
• Turn the Handle counter clockwise; open it and take the food out.
STEAMER FUNCTION
The appliance can be used as a Steamer. For this purpose use a special accessory that you
have bought with the appliance – the Steamer .
• Add some water (1/5 scale) into the Inner Pot. Put the Steamer with kitchen-stuff into the
Inner Pot and close the Lid.
• Turn the Relief Valve to down position.
• Power on the appliance with the Power Cord.
• Choosethebutton “Пароварка».
• Cooking time is up to your preferences – control the cooking time according to your food
or menu. For this use the “Время давления” button.
• Press the “Отмена” button if you would like to stop the cooking process.
CLEANING
• Remove the plug from the socket before cleaning wait until the appliance has normal tem-
perature.
• Take out the Inner Pot and clean it with a sponge or nonmetal soft brush, and then dry it
with towel.
• Rub the Inner Surface of the appliance with a soft cloth.
• Clean the outer coating of the appliance with a soft slightly wet towel. Never dip it in water
for cleaning or run water over it.
• Take off the Water Collector and clean it with a wet towel. Put it back as shown in the pic-
ture:
• Clean the Sealing Gasket, Relief Valve,and Floating Valve with soap water then dry them with
a towel. Aftercleaningputthe parts together again.
Attention! For your safety remember that when the appliance is on it must not contact with
water or other liquids especially the cord and the base of the appliance.
You must not dip the appliance into the water to avoid electric shock, fire or injuring.
Never wash the appliance in a dishwasher!
TROUBLESHOOTING
NO. A Problem The Cause The Solution
1 Difficult to close the
Lid
The sealing gasket is
not fixed well
Fix the sealing gas-
ket well
2 Difficult to open the
Lid
The pressure inside
is too high
Let the steam out
turning the relief
valve left or right
3 Steam leaks off the
Lid
There isn't a sealing
gasket in the Lid
Put the sealing
gasket into the Lid
(see “Appliance use”
paragraph)
The sealing gasket
isn't clean
Clean the Sealing
Gasket
The sealing gasket is
damaged or de-
formed
Change a broken or
deformed Sealing
Gasket to a new one
in a UNIT service
center
The Lid isn't fixed
properly
Fix the Lid properly
4 Indicating lights are
not on
The appliance isn't
powered on
Check the power
cord and the plug
Someotherproblems Send the appliance
to a UNIT service
center
5 E1 Short circuit of the
sensor
Send the appliance
to a UNIT service
center
E2 Open circuit of the
sensor
E3 Error of the pressure
regulator
E4 Protection against
overheating
SPECIFICATIONS
Model Rated Volt-
age
Power Capacity Diameter Working
Pressure
USP-1060D 220-240 V 900 W 5 L 22 cm 40-70 kPa
Max Pres-
sure
Keeping
warm Tem-
perature
Pre-set
Time
Pressure-
keeping
Time
Max keep
warm Time
Lifetime
80 kPa 70-80 ºC 0-24 hours 1-60 min 0-24 hours 20000 cycles
but not more
than 5 years
from the
date of the
purchase
The head office of the manufacturer : «UNIT Handelsgesellschaft G.m.b.H.»
131, Gersthofer Str., A-1180, Vienna, Austria
Exported by: «UNIT Electronics (H. K.) Limited»
3905 Two Exchange Square, 8 Connaught
Place, Central, Hong Kong
To Next Page
Loading...