device's related parameters and specifications).
Why is the speed slow when reading and writing data?
A: This product has been rigorously tested, the normal read and
write state of the hard disk read and write speed can reach the
USB3.2 (10Gbps) standard transmission speed. If the read/write
speed is slow, please make sure that the USB port/storage
device/data cable connected to the host computer is up to the
10Gbps version. In addition some 10Gbps M.2 hard disk
enclosure, it is not recommended to use a long cable to connect
this product, because too long cable will affect the 10Gbps signal
transmission, it is recommended to use 20-30cm cable to
connect the M.2 hard disk enclosure.
Package Content
1 x USB-C Bi-Direction Switch
1 x USB A to C Cable 1m
2 x USB C to C Cable 1m
4
To Next Page
Loading...