FIRST TIME CONTROL SETUP
SECTION B, PAGE 11
B9. SELECTING THE TYPE OF WELDER
The display will show one of the two displays:
OR
Press or to select your welder type.
B9.1 PRESS WELDER: If you told the SOLUTIONi that your welder was a
PRESS or PROJECTION WELDER, the display will show:
Where ##.# is the number you entered as the AREA of CYLINDER. This means
that the TIP FORCE between electrodes will be calculated as the air pressure
times this number. It will then exit out to the next setup program.
EXAMPLE: If the display showed:
and the air pressure regulator is set for 60psi, then the force between electrodes
would be:
TIP FORCE = 12.6 X 60 = 756 POUNDS
If your welder is a TRANSGUN or HANGING PORTABLE GUN (see
pictures on page B8), select PRESS or PROJECTION WELDER.
This is a PRESS or
PROJECTION WELDER
Want to change? PUSH
the YES or NO button
This is
A ROCKER ARM WELDER
Want to change? PUSH
the YES or NO button
TIP FORCE is
##.# times air psi
TIP FORCE is
12.6 times air psi
To Next Page
Loading...