Need help?Do you have a question about the Unitrol SOLUTIONi and is the answer not in the manual?
General| Protection | IP20 |
|---|---|
| Output Voltage | Max. 120 V DC |
| Communication Interface | Modbus |
| Protection Features | Overvoltage, Overcurrent, Short Circuit |
| Input Voltage Range | 100-240V AC |
| Frequency Range | 50/60Hz |
Instructions for connecting the line voltage to the control unit.
Instructions for properly connecting the ground wire for safety.
Connecting control wiring, including foot pedal and limit switches.
Verifying and setting the correct line voltage for the control.
Initial setup procedure using the Master Setup Program button.
Setting up the tip force calculator and window parameters.
Entering the weld cylinder's area in square inches.
Identifying the type of welder to configure the system correctly.
Performing the Learn Curve procedure to teach the control welding current.
To Next Page