Unitrol SOLUTIONi - SETTING TIP FORCE SYSTEM; CYLINDER AREA

FIRST TIME CONTROL SETUP
SECTION B, PAGE 2
B2. SETTING TIP FORCE SYSTEM
Press: 6 times. The display will show:
B3 PRESSURE VARIATION.
Press: The display will show:
If the 9181-05C DIFFERENTIAL PRESSURE TRANSDUCER option is installed in this control,
this number is the maximum change above or below the air pressure target that will be allowed
before a fault is displayed. If you leave it at 00, no fault will be shown.
For a typical welder, press:
B4. CYLINDER AREA
Press: and the display will show:
YES
0
YES
NO
MASTER
SETUP
PROGRAM
3
-
YES
979-SETUP for TIP
FORCE CALCULATOR and
TIP FORCE WINDOW.
SELECT=YES, SKIP=NO
Maximum AIR PRESSURE
VARIATION= +/-00 PSI
After entering data
Press YES
Area of CYLINDER is
00.0 SQUARE INCHES.
After entering data
Press YES
STEP
ENTER
YOU CAN ALWAYS GO DIRECTLY TO ANY SET-UP PROGRAM
Notice that there is a number 979 at the start of this display. That is the direct
access number for this particular setup program.
For example, you can go directly to this program by pressing:
If the number shown has a / (example: 987/71), press:
Also, if you have worked with SOLUTION controls in the past, the basic setup
programs for SOLUTIONi are the same but with the number 9 added in the front.
PROGRAM
9
9
7
STEP
ENTER
STEP
ENTER
PROGRAM
8
7
7
1
9