FIRST TIME CONTROL SETUP
SECTION B, PAGE 1
Let’s get started
Use the button to make changes in all of the SOLUTIONi control
control’s setup programs. Since this section is for SETUP purposes only,
descriptions of functions will be covered later in the USE section of this direction
book.
B1. Press: The display will show:
Push or wait about 10 seconds.
The display will now show:
This program will be used during production as described in the USE section of this direction
book.
As prompted in the display above:
Pushing will let you use that setup program.
Pushing will skip that setup program and go to the next setup program.
Pushing or will exit out of the
MASTER SETUP PROGRAM
And if you went too far, pushing will go back to the previous screen.
Do the following steps to set up your SOLUTIONi control when it is first
installed in your factory even if it was shipped mounted on a tested
welder. Changes need to be made to match your factory’s power
system. This will also be a check to make sure that it was set up
properly.
UNITROL SOLUTIONi
MASTER SETUP PROGRAM
Select=YES, Skip=NO
Exit =SINGLE,NW,RUN
900-Enter ALLOY
and GAUGE to select
RWMA weld schedule
SELECT=YES, SKIP=NO
To Next Page
Loading...