SECTION D, PAGE 14
8. Once the air pressure has been reached, the control will go through the weld
sequence. If the air pressure is NOT reached, this display will continue to be
shown until you release the foot or hand switch.
D6. RWMA WELDING SCHEDULES: Your SOLUTIONi control is
factory programmed with welding schedules for various alloys and metal
thicknesses.
D6.1 SELECTING AN RWMA SCHEDULE:
1. Press:
The display will show:
2. Press and the display will show:
If you want to weld LOW CARBON STEEL (CRS), press
The RWMA welding schedules are good starting points. They assume
that the proper electrode face shape is being used. These schedules
should get you very close to the desired results.
As shown below, you can trim these schedules to get the optimized weld
to match your particular test requirements.
SETUP
SETUP
900-Enter ALLOY
And GAUGE to select
RWMA weld schedule
SELECT=YES, SKIP=NO
CHOOSE MATERIAL:
LOW CARBON STEEL =1
Want to change? Push
the YES or NO button
To Next Page
Loading...