SECTION D, PAGE 15
The display will show:
3. Enter the thinnest gauge of the parts being welded. Then press
4. For example, if you are welding 16 gauge CR to another sheet of CR that is
the same or thicker, enter 16 gauge and the display will show:
5. If you want to weld this material, press
The display will show:
D6.2. USING SELECTED SCHEDULE: Press and the
display will show:
This Transformer TAP SWITCH position can be changed later if it is not correct for
the range of current needed for this part.
Set the pressure regulator to the PSI shown on the display and make a sample
weld.
Thinnest metal =00GA
After entering data
press “YES”
LOW CARBON STEEL 16G
WELDING SCHEDULE=805
Proceed? Push
the YES or NO button
Notice that this preset RWMA schedule is program 805. The next time
you want to weld this same material you could just go to PROGRAM 805
directly. This number can also be put on a production sheet. This
eliminates the need to go through the questions again.
PROGRAM 805 IS READY
Set TRANSF. TAP TO 1
Set PRES. REG. 57PSI
To Next Page
Loading...