SECTION D, PAGE 16
D6.2. TRIMMING THE RWMA SCHEDULE. If the results are not
exactly what you need to pass your quality tests, you can trim the welding
program by pushing
The display will show:
Press to see the rest of the RWMA welding schedule.
The trim changes in this RWMA welding program will stay in this program for
future use.
IF YOUR SOLUTIONi CONTROL DOES NOT HAVE QC IN THE MODEL
NUMBER, YOU HAVE TO BE IN CONSTANT VOLTAGE MODE (PROGRAM
997, ENTER, 11). In this case the display will show 00% for the WELD HEAT.
To make a starting weld, set WELD HEAT to 50%, make a test weld, and start
increasing the WELD HEAT% until you reach the desired weld quality.
D6.3 TAP FAULT FUNCTION: If the welding current in this program
requires that the WELD HEAT be set ABOVE 90% or BELOW 60%, the display
will show:
OR
SQUEEZE TIME 30CY←
WELD TIME 14 CY
WELD CUR. 11,600A
MOD.WELDCUR 11,600A
It is recommended that you only adjust the welding current line.
Leave the other values per the RWMA schedule. This should
ATTN: WELD CURRENT
too HIGH for
TRANSF. TAP POSITION
TURN TAP SW. HIGHER
ATTN: WELD CURRENT
Too LOW for
TRANSF. TAP POSITION
TURN TAP SW. LOWER
To Next Page
Loading...