SECTION D, PAGE 13
3. If you entered the correct information about cylinder area in section B of these
directions, the SOLUTIONi control will display:
4. Set the welding pressure regulator to the value displayed (35psi in this
example). If you have the 9181-16 Electronic Pressure Regulator option, this
pressure will be automatically set.
5. Before starting production, be sure that this transducer function is turned on. To
do this, press:
The display will show:
OR
If it shows ON, press
If it shows OFF, press
6. Press
7. When you push the foot switch or hand buttons to make a weld, the
SOLUTIONi control will close the electrodes and wait for the air psi, as shown
in step 3 above, to be reached. While this is happening, the display will scroll
across the bottom:
PROGRAM 001 IS READY
Set TRANSF. TAP to 1
Set PRES. REG. 35PSI
TRANSDUCER IS ON
Want to change? Push
the YES or NO button
TRANSDUCER IS OFF
Want to change? Push
the YES or NO button
To Next Page
Loading...