SECTION D, PAGE 12
Press and the display will show:
Close the foot switch or hand buttons and the electrodes will close. They will stay
closed but will not pass any current.
The display will show:
The number displayed represents the differential air pressure as measured by the
transducer.
Press and the SOLUTIONi control will reset and be ready to weld.
If your control does NOT have the letters QC
in the model number, skip to the next section.
5.5 USING THE PRESSURE TRANSDUCER IN
PRODUCTION:
1. Each weld program has a line:
Enter the desired TIP FORCE for the material being welded.
2. Press
Check AIR PRESSURE?
Push foot switch or
Hand buttons
AIR PRESSURE= ##PSI
When finished
Press STEP
When finished
press STEP
To Next Page
Loading...