Unitrol SOLUTIONi - HEAT CHANGE “ON THE FLY

SECTION C, PAGE 6
SOLUTION PERSONALIZATION
C3. HEAT CHANGE “ON THE FLY”
Your SOLUTIONi control can be used to increase or decrease in WELD
HEAT% using two buttons on the keypad without going into the welding program
and even if the keypad is locked.
Each time you push the WELD
HEAT% will increase by 1%.
Each time you push the WELD
HEAT% will decrease by 1%.
To use this feature and set + and - limits:
Press:
The display will show:
Push and the display will show:
PROGRAM
9
8
7
7
8
MODIFIED HEAT LIMITS
MAXIMUM “+CHANGE”=0%
Want to change? Push
the YES or NO button
YES
MODIFIED HEAT LIMITS
MAXIMUM “+CHANGE”=0
after entering data
Press YES
1
+
3
-
STEP
ENTER