SECTION C, PAGE 7
Enter the maximum WELD HEAT% increase that you want to allow from the
keypad and press
The display will show:
Push and the display will show:
Enter the maximum WELD HEAT% decrease that you want to allow from the
keypad and press
If your control does NOT have the letters QC
in the model number, skip to C7.
C4. EHR/FAULT RELAY ASSIGNMENT.
The control has a relay that can be jumper selected to be used in one of two
ways:
C4.1 EHR – End Of Hold OPERATION. When the J3 jumper is in the
EHR position, the relay will close at the end of every weld.
If the button is pushed, the EHR relay will NOT close.
EXCEPTION: If an external NO WELD switch is connected to terminal NW1 and
this switch is OPEN, the EHR relay will still close at the end of a sequence.
MODIFIED HEAT LIMITS
MAXIMUM “-CHANGE”=0%
Want to change? Push
the YES or NO button
MODIFIED HEAT LIMITS
MAXIMUM “-CHANGE”=0
after entering data
Press YES
To Next Page
Loading...