SECTION C, PAGE 5
If the keylock is in the LOCK position and you try to make a change not permitted
by the security level chosen, you can enter this code and then make changes.
Once you push SINGLE, NO WELD, or REPEAT to exit out, you will have to go
through the same procedure if you want to get back into a locked program.
C2.4 VIEWING WELDING SCHEDULES WITH KEY IN LOCK
POSITION: If the key is in the LOCK position, the control is the STANDARD
KEYBOARD LOCK mode, and you try to enter a welding program, the display will
show:
Enter the security code and press . You will be able to view and change
anything in the PROGRAM.
If you do not know the security code, just press . The display will show:
and then go to the opening screen of the last WELD PROGRAM. If you try to
change any line other than REPEAT OFF TIME, the control will show this display
while flashing the word LOCK along the right edge and then exit out:
Keyboard is locked
Bypass keylock-enter
Security code = ___
Then press YES
SQUEEZE TIME 00CYL
WELD TIME 00 CY0
WELD HEAT 83%C
MOD.WELD HEAT 83%K
To Next Page
Loading...