Unitrol SOLUTIONi - IDENTIFYING TYPE OF WELDER

FIRST TIME CONTROL SETUP
SECTION B, PAGE 5
B5. IDENTIFYING TYPE OF WELDER
B5.1 PRESS and PROJECTION WELDERS, SINGLE PISTON CYLINDER
These welders use a single-piston air cylinder to directly push the electrodes
closed.
For these types of welders, enter the AREA of CYLINDER as listed
in the SINGLE PISTON table in section B4.1 into PROGRAM 979.
Identify your type of welder and follow the directions
on the following pages to enter the proper number for
AREA of CYLINDER.
TYPICAL PRESS
WELDER WITH
A STANDARD
SINGLE-PISTON
AIR CYLINDER
ON TOP OF WELDER
TYPICAL PRESS
WELDER WITH
A STANDARD
SINGLE-PISTON AIR
CYLINDER
ON TOP OF WELDER.
THIS WELDER ALSO HAS
A RETRACT FEATURE
TYPICAL PROJECTION
WELDER WITH
A STANDARD
SINGLE-PISTON AIR
CYLINDER
ON TOP OF WELDER.
THIS WELDER ALSO HAS
A RETRACT FEATURE
TYPICAL PROJECTION
WELDER WITH
A STANDARD
SINGLE-PISTON
AIR CYLINDER
ON TOP OF WELDER
TYPICAL SEAM PRESS
WELDER WITH
A STANDARD
SINGLE-PISTON
AIR CYLINDER
ON TOP OF WELDER