FIRST TIME CONTROL SETUP
SECTION B, PAGE 4
B4.2 CYLINDERS OVER 99.9in
2
*For cylinders over 99.9 square inches, exit out of this set up
program by pressing:
Then press:
The display will show:
Press: and the display will show:
And then it will return to:
To get back to the setup previous setup program press: 7 times.
The display will show:
Press one time and then press one time.
The display will show:
CYLINDER AREA RANGE
Is 0-99.9 SQUARE IN.
Want to change? PUSH
The YES or NO button
CYLINDER AREA RANGE
Is 0-999 SQUARE IN.
Want to change? PUSH
The YES or NO button
979-SETUP for TIP
FORCE CALCULATOR and
TIP FORCE WINDOW.
SELECT=YES, SKIP=NO
Area of CYLINDER
000 SQUARE INCHES.
After entering data
Press YES
To Next Page
Loading...