Unitrol SOLUTIONi - ENTERING A WELDING PROGRAM

SECTION D, PAGE 1
SOLUTION IN PRODUCTION
D1: ENTERING A WELDING PROGRAM:
D1.1 CREATE PROGRAM: To create a new WELDING PROGRAM or
modify an existing one, turn the KEYLOCK to the OPEN position and press:
where ### is from 001 to 799.
The display will show:
OR
D1.2 VIEWING OR MODIFYING AN EXISTING WELDING PROGRAM:
If PROGRAM ### IS READY is shown, some data is already in this PROGRAM
number. Press if you want to check this PROGRAM or make changes.
Press and another number if you want to find an EMPTY program.
PROGRAM
When entering welding program numbers, you do NOT have to enter
zeros (0) in front of numbers. Just enter a 1, 2, or 3 digit number.
PROGRAM ### is empty
Press ENTER to
program.
PROGRAM ### IS READY
Press ENTER to
Program.
PROGRAM
#
#
#
STEP
ENTER
STEP
ENTER