SECTION D, PAGE 2
D1.3 ENTERING A NEW WELDING PROGRAM:
If PROGRAM ### is empty is shown, there is no data in this program. Press
and the display will show the first four lines of the welding program:
The ← on the right edge shows the line that can be changed.
On the display above, the arrow is pointing to the SQUEEZE TIME. To enter a
value for SQUEEZE TIME in this program, just push the desired keypad numbers
until the display shows the proper value.
S
SQUEEZE TIME 00CY←
WELD TIME 00 CY
WELD HEAT 00%
MOD.WELD HEAT 00%
You can move through a WELDING PROGRAM in many ways:
Push this button quickly and the ← will move down to the next
line even if it is 00.
Push and hold down this button and the ← will go to the next
line that has a number already entered and stop even if you
have the button still held down.
Push this button and the display will move to the next page of 4
lines.
Push this button and the ← will move up one line.
Try using these buttons and you will see how easy it is to move through a
welding program.
To Next Page
Loading...