Unitrol SOLUTIONi - USING THE DIFFERENTIAL PRESSURE TRANSDUCER

SECTION D, PAGE 10
SOLUTION IN PRODUCTION
D5. USING THE DIFFERENTIAL PRESSURE TRANSDUCER:
The SOLUTIONi control, when ordered with the QC package, will wait until the
ELECTRODE FORCE has reached the program selected value before welding.
D5.1 SETTING EFFECTIVE CYLINDER AREA: Before you turn the
transducer on be sure that the effective air cylinder area was entered into
PROGRAM 979 as directed in sections B2 through B9.
D5.2 TURNING THE TRANSDUCER ON: Press:
The display will show:
OR
Press if the TRANSDUCER is OFF is shown.
Press if TRANSDUCER is OFF is shown.
Use of this DIFFERENTIAL PRESSURE TRANSDUCER will eliminate
the need for having any SQUEEZE TIME in a weld program. This will
make the welding sequence as fast as possible while producing high
quality welds.
The transducer, if used properly, will eliminate metal expulsion (flash),
minimize surface indentation at the weld zone, and extend electrode life.
PROGRAM
9
7
9
TRANSDUCER IS OFF
Want to change? Push
the YES or NO button
TRANSDUCER IS ON
Want to change? Push
the YES or NO button
YES
NO
STEP
ENTER