Unitrol SOLUTIONi - SETTING SECONDARY CURRENT MONITORING SYSTEM

FIRST TIME CONTROL SETUP
SECTION B, PAGE 17
If this control does not have the letters QC in the
model number, skip the rest of the FIRST TIME
CONTROL SETUP.
If your control has a primary Current
Transformer (CT) installed inside the
cabinet as in the photo to the right,
skip to B14.
If the KVA of your welder was known when the
control was built at Unitrol, the CURRENT
MONITORING settings were made to this control
prior to shipment from Unitrol. This will be shown on the serial number
page of at the front of this direction book. If the calibration and setting
for SECONDARY CURRENT is shown on that page, skip to B14.
B13. SETTING SECONDARY CURRENT MONITORING
SYSTEM
Press:
The display will show:
SKIP
SKIP
SKIP
SECONDARY CUR SYSTEM
Want to change? Push
The YES or NO button
PROGRAM
9
8
7
9
9
STEP
ENTER