FIRST TIME CONTROL SETUP
SECTION B, PAGE 16
This is the LEAST SAFE mode and should only be used if you have the
Unitrol SOFT TOUCH safety system installed on this welder, or you have a
light curtain properly installed to protect the operator from pinch point injury
during a weld sequence.
Press to exit out of this program.
B12. SETTING WELDER TRANSFORMER STYLE:
Your SOLUTIONi control can operate two types of welding transformers.
Press:
The display will show:
Most package transformers are WOUND CORE style. These are transformers with
metal casings on the outside of the transformer.
Other transformers do not have metal casings on the outside and are usually
STACKED CORE transformers.
Check with the welder manufacturer to identify your transformer style. If you
cannot get this information, leave the control in WOUND CORE.
Press and the program will exit out.
If you have identified the welding transformer as a STACKED CORE style, press
the to make the change.
WOUND CORE TRANSF.
Want to change? Push
the YES or NO button
To Next Page
Loading...