FIRST TIME CONTROL SETUP
SECTION B, PAGE 18
Press if your control has a SECONDARY CURRENT
COIL as shown in the photo to the right.
The display will show:
This program selects the maximum secondary current that will be read by this
pickup coil. If you do not know the maximum secondary current for your welder,
use the following chart to make this selection:
If the maximum current number is shown on the display, press to exit out of
this program.
If the maximum current number on the display is NOT correct, press
The display will show:
Press the numbered button on the keypad that matches the desired range.
The display will now briefly show the selected MAXIMUM CURRENT RANGE
and then exit to:
SECONDARY CUR SYSTEM
100KA MAX CURRENT =1
Want to change? Push
the YES or NO button
100KA MAX CURRENT =1
50KA MAX CURRENT =2
25KA MAX CURRENT =3
10KA MAX CURRENT =4
To Next Page
Loading...