FIRST TIME CONTROL SETUP
SECTION B, PAGE 19
B13.1 SETTING CURRENT RANGE SWITCH
After setting the control’s electronic system for current range, a DIPswitch has to be
set mechanically to match this range.
For model 9180iQC (REMOTE
CONSOLE)
1. Remove the blue back plate on
the remote console.
2. Locate the 4-position
DIPswitch as shown in the
photo.
3. Pull the switch finger that
matches the desired MAXIMUM
CURRENT RANGE (chart on
page A16) to the left (ON) as shown in the photo. In this
photo, the #3 (25KA) switch is selected.
4. Push the other three fingers to the right (off).
5. Install the back plate and mounting angles per the photo to
the right.
To Next Page
Loading...