Unitrol SOLUTIONi - SETTING SECURITY SYSTEM

SECTION C, PAGE 3
SOLUTION PERSONALIZATION
C2. SETTING SECURITY SYSTEM: Your SOLUTIONi control has a
built-in security system to prevent unauthorized changes to welding or setup
programs. The control will be either LOCKED or OPEN depending on the key
position.
C2.1 SECURITY LEVELS: With the key in the LOCK position, the
following operations will be allowed (YES) or blocked (NO):
FUNCTION
STANDARD
FULL MANAL
FULL AUTO
Review WELDING PROGRAM DATA
YES
NO
NO
Change WELDING PROGRAM DATA
NO
NO
NO
Select NEW WELDING PROGRAM
YES
NO
NO
Change welding mode SINGLE, NO WELD, or REPEAT
YES
YES
NO
Link PROGRAMS TO INITIATION-A AND INITIATION-B in
PROGRAM 995
YES
NO
NO
CHANGE REPEAT OFF TIME in WELDING PROGRAMS
YES
YES
NO
Reset PARTS OR BATCH COUNTERS in PROGRAM 991
YES
NO
NO
Measure TIP FORCE in PROGRAM 996
YES
NO
NO
Turn TRANSDUCER ON/OFF in PROGRAM 996
NO
NO
NO
Set WELD CYLINDER AREA in PROGRAM 997
NO
NO
NO
Select or change any of the SETUP PROGRAMS
NO
NO
NO