SECTION C, PAGE 2
The display will now show:
Enter the number of parts that will be in a BATCH and press . The display
will exit out of this set up program.
C1.2 USING BATCH COUNTER: If you entered a number for the
BATCH COUNTER and start to weld, the welder will continue to operate and after
each weld will display:
This indicated that there are 437 more parts to make before the control will stop.
After the last weld is made for the last part in the batch, the display will show:
The welder will not operate until you push . This will now reset the BATCH
COUNTER.
PARTS PER BATCH =000
After entering data
Press YES
PROGRAM 055 IN USE
00,437 LEFT IN BATCH
00,063 PARTS MADE
BATCH is completed.
PRESS “YES”
to start a new BATCH
To Next Page
Loading...