Unitrol SOLUTIONi - SETTING COUNTING SYSTEM

SECTION C, PAGE 1
SOLUTION PERSONALIZATION
Your SOLUTIONi control can be personalized to use functions to best match
your needs.
C1. SETTING COUNTING SYSTEM: The SOLUTIONi control has
several counting functions built into the system. They include WELD COUNTER,
PARTS COUNTER, and BATCH COUNTER.
Press:
The display will show:
Press and the display will show:
If you are making more than 1 weld per part and want to count FINISHED parts,
enter the number of WELDS on each PART and then press
If you want to only count WELDS, leave 000 and press
C1.1 SETTING BATCH COUNTER: The display will now show:
If you want to have the control stop operation when a predetermined number of
finished parts has been completed, press
YES
YES
9
9
PROGRAM
1
The COUNTER is ON
Want to change? Push
the YES or NO button
WELDS PER PART = 000
After entering data
Press YES
NO
BATCH COUNTER is OFF
Want to change? Push
the YES or NO button
YES
STEP
ENTER