SECTION D, PAGE 18
7. ELECTRONIC PRESSURE REGULATOR OPTION 9181-16
This option sets an electronic pressure regulator to provide the requested air
pressure in response to the TIP FORCE line in a program. If this option was
ordered with your control the system is factory set to operate.
7.1 EQUIPMENT: An electronic pressure regulator has been provided with
your control. This unit is installed on your air system in full replacement of the
existing mechanical WELDING PRESSURE REGULATOR. It should be located
AFTER the filter and before the oiler.
7.2 OPERATION: Each welding program has a line:
When a value is entered on this line and the button is pushed, the
display will show:
At this time the ELECTRONIC PRESSURE REGULATOR will change to this
value and the display on the regulator will confirm the pressure.
Note that the pressure might be as much as 1psi higher than the requested value.
PROGRAM ###IS READY
Set TRANSF. TAP to 1
Set PRES.REG. 35PSI
To Next Page
Loading...