FIRST TIME CONTROL SETUP
SECTION B, PAGE 22
You can switch back and forth between these two modes with just a few
keystrokes.
Before using this control in the CONSTANT CURRENT mode, you need to follow
a one-time set-up procedure to “teach” the SOLUTIONi control the welding
current created by different percentage heat settings on your particular welder.
B14.3 DOING THE LEARN CURVE:
1. Press:
The display will show:
If your welder does NOT have a TAP SWITCH, PUSH
If your welder HAS a TAP SWITCH, press and
enter the total number of tap positions.
If you have a HEAT STEPPER turned on at this time,
the display will tell you to go to PROGRAM 988 and
turn it off.
The display will now show:
Total TRANSF. TAPS=1
Want to change? Push
the YES or NO button
LINE VOLTAGE CALIB.
LINE VOLTAGE is ---
After entering data
Press YES
To Next Page
Loading...