10 11
Hearing aids with custom shells
1. Hold the custom shell
between your thumb and
index nger. The opening
should be pointing in
towards your ear canal
with the hearing aid
resting above your ear.
2. Carefully insert the
custom shell into your
ear. The shell should t
into your ear snugly and
comfortably.
3. Place the hearing aid over
the top of your ear.
1.
2.
3.
Turning your hearing aids on and o
Your hearing aids have a three-position battery
door that acts as an on/o switch and that
allows access to the battery compartment.
1. On: Close the battery door
fully.
Note: It may take ve seconds
before the hearing aid turns
on. Your hearing healthcare
professional can increase the
start up delay if required.
2. O: Partially open the
battery door.
3. Open: Fully open the battery
door to access and change
the battery.
Note: When turning your
hearing aid on and o while it
is on the ear, grasp the top and
bottom of the hearing aid with
your index nger and thumb.
Use the index nger of your
opposite hand to open and
close the battery door.
1.
1.
2.
3.
To Next Page
Loading...
