Quick guide
beeps every
minutes
Low battery warning
Charging your hearing aids
Before using your hearing aids for the rst time,
it is recommended to charge them for 3 hours.
Aer placing your hearing aid in the
charger, the indicator light on the
hearing aid will show the charging
state of the battery until it is fully
charged.
Charging: Slow blinking
indicator light
Fully
charged: Solid green indicator
light
Le & right hearing aid markings
Red marking for
right hearing aid.
Blue marking for
le hearing aid.
Multi-function button with indicator light
The button has several functions,
the primary function is as an on/o
switch. Together with your hearing care
professional, you can decide if it also
allows for volume control and/or program
change. This is indicated in your individual
instructions.
On/O: Firmly press the lower part of the button for
3 seconds until the indicator light blinks.
On: indicator light is solid green
O: indicator light is solid red
Phone calls: If paired with a Bluetooth® enabled phone,
a short press will accept and a long press will reject an
incoming call.
Enter flight mode: When device is o, press the lower part
of the button for 7 seconds until the solid orange light
appears. Then release the button.
Tap control
(only available for models V9, V7, V5 and V3)
If paired with a Bluetooth® enabled device, multiple
functions can be accessed using tap control, please refer
to chapter 9. This is also indicated in your individual
instructions.
To use tap control tap the top of your ear twice.
Bluetooth
®
is a registered trademark owned by the Bluetooth SIG, Inc.
and used under license by Unitron.
To Next Page
Loading...
Need help?
General
