Item No. 0BL-00-010 Rev. 12/21/2017 Copyright (C) 2017, Universal Metal Industries, Inc. Prov. 22:29 Page 1
INSTALLATION INSTRUCTIONS &
USE & CARE GUIDE
Trade-Wind
®
S7200CD Series BBQ Hood
S7200CD Series Models:
No Blower 1200 CFM 2300CFM
S7236CD S723612CD N/A
S7242CD S724212CD N/A
S7248CD S724812CD N/A
S7254CD N/A S725423CD
S7260CD N/A S726023CD
S7266CD N/A S726623CD
S7272CD N/A S727223CD
CONTENTS:
Part 1 - Planning The Installation
Part 2 - Electrical Connection
Part 3 - Direction of Vent and Securing The Hood
Part 4 - Use & Care
Before beginning installation, please thoroughly read and become familiar with these instructions. Installation and
service must be completed by a qualified installer. Failure to properly install this product may void the warranty.
Please be advised that the Trade-Wind
®
S7200CD Series BBQ Hood MAY NOT be installed on a Patio or Lanai
area that does not have a roof over the BBQ Hood to protect it from direct rain or potential water ingress. This
Hood should be installed with a MINIMUM of three (3) feet of weather proof roof coverage on all sides that are not
protected from direct rain by an adjacent wall.
It is required that all duct work and roof openings be thoroughly sealed with the applicable tape and/or roof sealant
to prevent ingress of water.
Please leave Installation Instructions with the BBQ hood owner.
Please keep Installation Instructions for local electrical inspector’s use and for future reference.
WARNINGS: Must be followed carefully to avoid personal injury.
IMPORTANT: Must be followed carefully to avoid damage or incorrect installation.
TIPS: Contain helpful information to facilitate installation.
READ AND SAVE THESE INSTRUCTIONS
WARNING! TO REDUCE THE RISK OF FIRE, ELECTRICAL SHOCK, OR INJURY TO
PERSONS OBSERVE THE FOLLOWING:
a) Use this unit only in the manner intended by the manufacturer. If you have any questions, please contact the
manufacturer at the address or telephone number listed in the warranty.
b) Before servicing or cleaning unit, switch power off at service panel and lock service panel and lock the service
disconnection means to prevent power from being switch on accidentally. When the service disconnecting means
cannot be locked, securely fasten a prominent warning device, such as a tag to the service panel.
To Next Page
Need help?
General