9 10
BASIC SETUP
BASIC SETUP
Pre-Programmed Code Method
Pre-Programmed Code Method
STEP 4:
Press the P-PRO display button
to select the Pre-Programmed
Method.
The screen will then display the five
Components from Page 1 of the MAIN
menu.
To display Page 2 of the MAIN menu
that lists an additional five Components,
simply press the PAGE ( ) ( ) buttons.
STEP 5:
Press the Component display button you
want to program.
For example: If you want to setup the TV
Component button, press the TV
Component display button. The display at
the bottom of the LCD screen will flash
“FROM - TABLE”.
STEP 6:
In this step you verify the type of compo-
nent you plan to operate with this compo-
nent button. For example: If you plan
to operate the TV component with the TV
button, simply press the TV display button
once again. However, if for example you
are setting up AUX to operate a second
DVD Player, you would first need to press
AUX in Step 5, and then DVD in Step 6.
FIRST FIVE
DEVICE NAMES
PAGE
BUTTONS
P-PRO
BUTTON
To Next Page
Loading...
