MX-3000 COLOR TOUCH SCREEN
Using the Charging Base
Plug the 5V DC adapter into a
power outlet and into the back of
the charging base.
Gently place the MX-3000 into the
cradle of the charging base.
Push down on the base of the
MX-3000 until you hear and feel a
firm “click”.
The Status light should immediately
light. Red indicates that it is
charging. Blue shows that it is fully
charged. There is no harm in leaving the MX-3000 on its charging base
whenever it is not in use.
Programmable only by a URC Certified Professional
To fully automate your audio/video system, the programmer must have
detailed knowledge of each component as well as how the system is
connected and operated. Only a trained and certified professional
audio/video installer can install a MX-3000 remote control in a timely and
efficient manner.
The MX-3000 on it’s Charging Base.
Page 2
To Next Page
Loading...