3. Press the VOL button on the LCD for Volume Punch
Through, the PLAY for Transport Punch Through or the
CH for Channel Punch Through depending upon which
Punch Through you want to erase.
4. Press the DEVICE button from which you wish to erase
punch through.
5. Press the same DEVICE button once again.
6. Punch through is erased when the same device button is
pressed the second time.
7. Repeat from Step 2 to erase the Punch Through for other
devices.
8. Exit from Punch Through mode by pressing the MAIN
button and then exit from the SETUP mode by pressing the
MAIN button once again.
38
8. Erasing Existing Programming
To Next Page
Loading...
