Universal Space Super Big Rig - Troubleshooting and System Recovery; Common Error Solutions

Super big rig Manual Rev.1.0
19
7. ERROR MESSAGE AND RECOVERY
7.1 Trouble Shootings
 Please confirm whether every connector connected tightly.
Troubles Cause Methods
Cannot start
Frame assembly connector fall off Please plug in connector tightly
Frame assembly fault Please contact with dealer
Power cutting
Circuit protector make power SW
in cutting state
Please turn on power SW again. If
appeared again and again, machine
has anomaly. Please contact with
dealer
Coin mech. no
reaction
Coin mech. fault Change coin mech.
Coin mech. signal cable loosen
Check coin mech. signal line loosen or
not
IO control board fault Change IO board
Speaker no
sound
Volume set too low Please raise the volume
Connector falls off Please plug in connector tightly
PCB fault Please change PCB
Speaker fault Please change speaker
Monitor black
screen
Connector falls off Please plug in connector tightly
Monitor fault Please change monitor
Monitor blue
screen
PC power cord is loose Check PC power cord whether is loose.
VGA signal cable is loose. Check VGA signal whether is loose.
PC video card is loose. Plug video card again.
PC into protection
Open front cover, if power on light flash
all the time. Press power button 30s,
then restart. If no work, please call
Lenovo: 8008108888
Playing normal,
but appear
system halted
Video card is loose or poor contact Plug video card again
PC crash Restart or system recovery
Start button no
reaction
Connector falls off Please plug in connector tightly
Button breakdown Please change star button
Thumb reverse Gun calibrate reverse